A range of robust punch and die action cutters. The cutting edges are case hardened and ground to very high tolerance for exceptional accuracy. Suitable for cutting paper, light carton board, tissue paper, film and foil. Accords with relevant national and international standards: ISO, TAPPI, SCAN etc....
(100cm² area) Circular sample cutter 100cm² for the accurate cutting of corrugated board in preparation for flat crush test. Accords with relevant national and international standards.
(50cm² & 20cm²) area cutters also available.
For cutting samples of 100 cm² for grammage determination.
Produces a circular sample of 100 cm². Appropriate for cutting samples from paper, single layer board, foils and textiles, etc.
Applicable standard: DIN 53104
CONCORA MEDIUM FLUTER
For the preparation of corrugated samples for CMT and CCT tests
Directly heated fluting plates
Energy optimised – power consumption only 200 W
Temperature control via digital display
Optionally available with interchangeable fluting plates
For clean and parallel cutting of corrugated board in preparation for the edge crush test (ECT).
HM208 for board thickness up to maximum 8mm
HM212 for board thickness up to maximum 12mm
Sample length 100mm
Sample width 25mm
Helps to make coplanar samples for ECT test.
High-speed sample saw with accurate cuts. Automatic feed and pneumatic ejection of the cut samples. Counter shows the number of cuts.Exhauster for the removal of cutter dust.
Applicable standards: DIN EN ISO 3037, APPITA 1301.444s, DIN 53149, FEFCO Nr. 8, ISO 13821, SCAN P33, TAPPI T811, T823, T838, T839
Multi strip cutter for the simultaneous cutting of 5 strips for tensile tests (15 mm width). The sample is placed in the cutter and moved through the unit by turning the manual handle.
The sample is cut into 5 x 15 mm wide samples simultaneously.
The multi strip cutter has proved itself in countless applications, especially in the foil & plastic film industries. The operator turns the crank hank one time around to produce 10 strips of 15 mm cut width simultaneously. Especially suitable for plastic films. Available sample width versions:12.7 / 15 / 25 / 25.4 / 50 mm.
For the easy cutting of samples for bending stiffness and tearing tests. A triple shear knife cuts the sample from the material. Available in 2 sizes:63 x 76 mm or 63 x 63 mm for Elmendorf tear test sample.38 x 75 mm for bending stiffness samples.
Table punch with matrix. This sample punch is especially designed for punching voluminous materials (e.g. non-woven for sanitary products, pulp samples). The top knife is constructed as a punching tool; a plastic shelf serves as a bed. Punching tool is available in various sizes: Round: all sizes up to 150 mm diameter.
Rectangular, quadratic: up to 200 x 200 mm
Heat sealer that used to make laboratory seal samples under precisely controlled conditions. Heat, Pressure, Dwell and Delay times can be varied to match production line conditions.
Application: Plastic films, laminates. Foils